Towards imaging of atmospheric trace gases using Fabry-Pérot interferometer correlation spectroscopy in the UV and visible spectral range

• Verfasst von: Kuhn, Jonas [VerfasserIn]
• Verfasst von: Platt, Ulrich [VerfasserIn]
• Verfasst von: Bobrowski, Nicole [VerfasserIn]
• Titel: Towards imaging of atmospheric trace gases using Fabry-Pérot interferometer correlation spectroscopy in the UV and visible spectral range
• Verf.angabe: Jonas Kuhn, Ulrich Platt, Nicole Bobrowski, and Thomas Wagner
• E-Jahr: 2019
• Jahr: 1 February 2019
• Umfang: 13 S.
• Fussnoten: Gesehen am 28.03.2019
• Titel Quelle: Enthalten in: Atmospheric measurement techniques
• Ort Quelle: Katlenburg-Lindau : Copernicus, 2008
• Jahr Quelle: 2019
• Band/Heft Quelle: 12(2019), 1, Seite 735-747
• ISSN Quelle: 1867-8548
• DOI: doi:10.5194/amt-12-735-2019
• Datenträger: Online-Ressource
• Sprache: eng
• K10plus-PPN: 1662477198

Abstract

Abstract. Many processes in the lower atmosphere including transport, turbulent mixing and chemical conversions happen on timescales of the order of seconds (e.g. at point sources). Remote sensing of atmospheric trace gases in the UV and visible spectral range (UV-Vis) commonly uses dispersive spectroscopy (e.g. differential optical absorption spectroscopy, DOAS). The recorded spectra allow for the direct identification, separation and quantification of narrow-band absorption of trace gases. However, these techniques are typically limited to a single viewing direction and limited by the light throughput of the spectrometer set-up. While two-dimensional imaging is possible by spatial scanning, the temporal resolution remains poor (often several minutes per image). Therefore, processes on timescales of seconds cannot be directly resolved by state-of-the-art dispersive methods. We investigate the application of Fabry-Pérot interferometers (FPIs) for the optical remote sensing of atmospheric trace gases in the UV-Vis spectral range. By choosing a FPI transmission spectrum, which is optimised to correlate with narrow-band (ideally periodic) absorption structures of the target trace gas, column densities of the trace gas can be determined with a sensitivity and selectivity comparable to dispersive spectroscopy, using only a small number of spectral channels (FPI tuning settings). Different from dispersive optical elements, the FPI can be implemented in full-frame imaging set-ups (cameras), which can reach high spatio-temporal resolution. In principle, FPI correlation spectroscopy can be applied for any trace gas with distinct absorption structures in the UV-Vis range. We present calculations for the application of FPI correlation spectroscopy to <span class="inline-formula">SO₂</span>, <span class="inline-formula">BrO</span> and <span class="inline-formula">NO₂</span> for exemplary measurement scenarios. In addition to high sensitivity and selectivity we find that the spatio temporal resolution of FPI correlation spectroscopy can be more than 2 orders of magnitude higher than state-of-the-art DOAS measurements. As proof of concept we built a 1-pixel prototype implementing the technique for <span class="inline-formula">SO₂</span> in the UV. Good agreement with our calculations and conventional measurement techniques is demonstrated and no cross sensitivities to other trace gases are observed.